Design and Analysis of Cntfet Based Analog Circuits
Autor: Pritish Pani • February 12, 2017 • Research Paper • 2,624 Words (11 Pages) • 671 Views
A REPORT
ON
Design And Analysis Of Cntfet Based Analog Circuits
BY
Pritish Pani 2012A3PS129P
Prepared in partial fulfillment of the
Course EEE F366 Laboratory Project
Submitted to
Dr. Abhijit R. Asati
. Assistant Professor, EEE-Department, BITS-PILANI
BIRLA INSTITUTE OF TECHNOLOGY AND SCIENCE, PILANI
(MARCH 2015)
[pic 1]
Table of Contents
- Introduction…………………………………………………………………………………………..........................3
- Carbon Nano Tube Field Effect Transistor………………………………………………………................4
- Simulation Results..............................................................................................................8
- CNTFET based Inverter Simulation………………………………………………..............................8
- CNTFET based Multiplier Simulation.………………………………………………….......................9
3.2.1 Static Logic...............................................................................................9
3.2.2 Transmission Gate Logic...........................................................................12
3.2.3 Domino Logic..........................................................................................13
3.2.4 TSPC Logic..............................................................................................15
4. Conclusion...........................................................................................................................18
INTRODUCTION
With the channel length of the MOSFET set to fall below 10nm by 2020, silicon based technology will reach its limits. With the miniaturization of silicon based circuits reaching its physical limitations new technology is constantly being researched upon in a bid to mitigate the problems caused by the limitations and to provide with a solution that can coherently coexist with the existing silicon technology.
...